Elo TouchSystems TouchSystems CarrollTouch Prog User's Guide download pdf (Page 44)

CARROLL TOUCH Chapter 6 - Touch System Information

Touch System Diagnostics (CTDIAG) User’s Guide 6-3

- Reporting Method: Coordinate reporting or scan reporting is

active.

- Touch Mode:

Tracking Mode

Continuous Mode

Exit Point

Mode

, or

Enter Point Mode

is active, with or without an Exit

Point Modifier.

- Touch Scanning: Touch system is not detecting (off) or is

detecting (on) touch.

- Report Transfer: Smart-Frame Protocol reports are not sent (off)

or are sent (on) to the host.

- Flow Control: Hardware handshaking is not used (off) or is used

(on) to regulate serial communications.

• Failed Beam Report identifies failed infrared beams and analyzes, if

possible, the cause. Information comes from the

Get_Failed_Beam_Report (36H)

command. This report is not valid

for guided acoustic wave touch systems.

For detailed information on these commands, refer to the

Touch System

Programmer’s Guide

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 91 92

No comments

Elo TouchSystems TouchSystems CarrollTouch Prog User's Guide Page 44